Service is 200/35 ( currently costs $95 a month with no modem rental, which is a sin because the latency and reliability of the service is horrid, but it is our only option. I'm not ruling out the self purchased cable modem, I have had the modem for 3+ years and is still the current "non Altice service" given out today. Wan0 is currently a self purchased cable modem compatiable with Optimum Online. Obviously configuring another port/vlan tag for wan0. I've done all the hardware troubleshooting and disabling tso and such.Ĭan I put wan0 on a trunk interface as well?Ĭan I remove the dual bce card, enable em0, and reconfigure vlan10, vlan20, vlan172, wan0 to all be on em0? I keep getting interface errors on the bce0/1 card. I have an OptiPlex 9020 with an onboard em0 (disabled) and a dual bce0/1 pcie card in use. I'm delegated as part of a /23.Īrp -an | grep bce1 yields valid and accurate information. I was thinking about static assigning my wan_bce1 ip and mask to the wan_vlan42 just to see if I can see a mac on the other side. like possibly Optimum blocking oui ranges for Unifi. just in case I missed releasing something, etc. had link light (was thinking about needing a crossover device to device and all, just to rule out possible mismatch - didn't change anything)Įven bounced the opnsense box afterwards. always feels like I'm in Celebrity Jeopardy.Ĭreated vlan42, added it to the trunk, created vlan42 on bce0, assigned it to the wan0 interface, checked on Interfaces -> OverviewĬonfirmed wan0 was assigned to bce0_vlan42.Īssigned a switch port to vlan42, plugged the cable modem into the configured switch port, bounced the modem. Or can point out something I might have missed. unless someone else has something to share about getting this working w/ Optimum specifically. Think I'm going to tip my hat at Optimum. but I still should have been able to get to that host as I can get to to it when I get a dhcp address. it wouldn't care what was on the other side (as evidenced by L2 mac address on the other side.)Ĭonnected interfaces :: bce0_vlan42 -> unifi trunk -> cable bridge/modem -> provider gw and I have arp on opnsense. *BUT* dhcp relay wouldn't have anything to do with not passing icmp. maybe optimum isn't the bad guy here (not about this. No icmp to the default gw or any outbound host. Vlan42 is working, static assigned the bce1 dhcp to the bce0_vlan42.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |